Cisco 678 (DMT ONLY) - Windows

From FRII Support

Jump to: navigation, search

Contents

Cisco 678 Configuration Information for DMT in Windows

Here are the commands that need to be put into the CISCO 678 to set various modes for our customers. Right now we will only set them to Bridging mode, PPP mode with dynamic IP and NAT/DHCP, or PPP mode with static IP/subnet. Configurations for a firewall or anything else is not supported.

NOTE: The set web disable and set web port 8888 lines are needed to avoid router crashes due to a web interface bug/exploit. Upgrading to the latest version of the CBOS will also fix this bug.

Before the router can be configured, a terminal interface will need to be opened to communicate with the Cisco. Please refer to the documentation from Qwest for instructions on opening a hyperterminal session.

NOTE: If the Cisco prompts to "write" at any point during the config, please type "write" then press enter before proceeding to the next line.

bridging mode:

enable
set nvram erase
write
reboot

enable
set bridging rfc1483 enabled
set interface wan0-0 close
set interface wan0-0 vpi 0
set interface wan0-0 vci 32
set interface wan0-0 open
write
reboot

ppp single ip (dynamic or static) w/nat and dhcp:

enable
set nvram erase
write
reboot

enable
set ppp wan0-0 ipcp 0.0.0.0
set ppp wan0-0 login username@frii.com
set ppp wan0-0 pass password
set ppp restart enable
set dhcp server enable
set dhcp serv pool 0 dns 216.17.128.1
set dhcp serv pool 0 sdns 216.17.128.2
set nat enable
write
set interface wan0-0 disable
set interface wan0-0 vpi 0
set interface wan0-0 vci 32
set interface wan0-0 enable
write
set web disable
write
reboot

ppp static with routed network:

enable
set nvram erase
write
reboot

enable
set ppp wan0-0 login username@frii.com
set ppp wan0-0 pass password
set ppp restart enable
set int eth0 address ip address
set int eth0 mask netmask
write
set interface wan0-0 disable
set interface wan0-0 vpi 0
set interface wan0-0 vci 32
set interface wan0-0 enable
write
set web disable
write
reboot

* If they are using CBOS 2.3 or above, with a routed subnet, they will need to add the line "set ppp default disabled" after they type set web port 8888 command is entered.

Views
Personal tools