Cisco 675/678 (CAP ONLY) - Windows

From FRII Support

Jump to: navigation, search

Contents

Cisco 675/678 Configuration Information for CAP in Windows

Here are the commands that need to be put into the CISCO 675 to set various modes for our customers. Right now we will only set them to Bridging mode, PPP mode with dynamic IP and NAT/DHCP, or PPP mode with static IP/subnet. We will not do config of their firewall or anything else.

NOTE: The set web disable and set web port 8888 lines are needed to avoid router crashes due to a web interface bug/exploit. Upgrading to the latest version of the CBOS will also fix this bug.

Before the router can be configured, a terminal interface will need to be opened to communicate with the Cisco. Please refer to the documentation from Qwest for instructions on opening a hyperterminal session.

NOTE: The password you will enter doesn't need to be valid do to NAS port authentication but the cisco will require a password. For more information about NAS port authentication review the relate article below.

NOTE: If the Cisco prompts to \"write\" at any point during the config, please type \"write\" then press enter before proceeding to the next line.

bridging mode:

enable
set nvram erase
write
reboot

enable
set bridging rfc1483 enable #There is no space between rfc and 1483
set interface wan0-0 close
set interface wan0-0 vpi 1
set interface wan0-0 vci 1
set interface wan0-0 open
write
reboot

ppp single ip (dynamic or static) w/nat and dhcp:

enable
set nvram erase
write
reboot

enable
set ppp wan0-0 ipcp 0.0.0.0
set ppp wan0-0 login username@frii.com
set ppp wan0-0 pass password
set ppp restart enable
set dhcp server enable
set dhcp serv pool 0 dns 216.17.128.1
set dhcp serv pool 0 sdns 216.17.128.2
set nat enable
set web disable
set web port 8888
write
reboot

ppp static with routed network:

enable
set nvram erase
write
reboot

enable
set ppp wan0-0 login username@frii.com
set ppp wan0-0 pass password
set ppp restart enable
set int eth0 address ip address
set int eth0 mask netmask
set web disable
set web port 8888
write
reboot

* If they are using CBOS 2.3 or above, with a routed subnet, they will need to add the line \"set ppp default disabled\" after they type the set web port 8888 command. \"set ppp default disabled\" does not appear to work on the latest versions of the CBOS. We have not been able to obtain a new command, though the command may no longer be needed.

Do NOT allow public read permissions for this entry.
Views
Personal tools